A MicroLaserPeel removes a thin layer of damaged skin to improve texture and provide a more youthful appearance. It provides superior results because it can be administered with great precision of depth. The procedure is performed in your physician’s office and can be custom tailored to your specific skin conditions and desired outcome.
The MicroLaserPeel’s beam is scanned over a treatment area to remove a very thin layer of the skin. Removing the top layer eliminates some of the damaged cells that can give skin a tired, aged look. As the skin heals, fresh cells grow and resurface the treated area. The result is healthier-looking skin, often with reduced wrinkles and improved color evenness. Patients often say that it looks like their skin went from looking tired to vibrant.
• Mild wrinkles
• Sun damage (e.g., freckles)
• Pigment irregularities
Most skin areas can be treated. Popular treatment areas are the face and neck, though some people also treat the chest and hands. You should discuss your needs with your physician.
Excellent results can be obtained in just one treatment, however the number of treatments needed may vary from patient to patient. Your physician can personalize a plan based on your specific needs and may chose to combine MicroLaserPeel with other aesthetic procedures to further personalize your treatment.
Your skin will be cleaned in the treatment area and your eyes will be protected with safety shields. The physician will position the laser handpiece above the skin and will hold it in place as the computer-guided scanner moves the laser beam around the treatment area. Depending on the size of the area being treated, the procedure usually lasts 15 to 30 minutes.
One of the primary advantages of MicroLaserPeel is that it causes little pain because it does not penetrate very deep into the skin. At its most shallow settings, most people can tolerate treatment with no anesthetic at all. At deeper settings, a topical numbing cream is typically used.
Immediately after the treatment you will notice that the skin has a “frosty”appearance. This is the dehydrated skin that will peel away within next few days following the treatment. You may experience some skin redness and a sensation resembling sunburn, as well as mild swelling.
Depending on the depth of treatment, most patients feel comfortable enough to return to work within 3 to 4 days – an attribute that has given rise to the nickname “the weekend peel.”
You may be given skin care products and instructions on how to use them. Your skin will be sensitive to ultraMicroLaserPeel Superficial Skin Resurfacing | MicroLaserPeel®
Great results with minimal downtime violet light after the procedure, so you must avoid direct sun exposure until fully healed. It is recommended that you always use some level of solar protection to avoid sun damage and premature aging of your skin.
Because only the outer layer of skin is treated, most
patients notice an obvious improvement in tone, texture
and color evenness once the skin heals in approximately